The ED3141 is a point-to-point Ethernet Extender designed to operate in harsh environments that efficiently extends 10/100 Ethernet circuits to over 300meters (984feet) at 50Mbps using existing cross-over pair copper wire. The ED3141 functions at temperatures ranging from -40C to 75C (-40F to 167F) and is tested for functional operation @ -40C to 85C (-40F to 185F). The ED3141 will allow Ethernet connectivity in existing facilities without pulling extra cable. This is the perfect solution to Ethernet on the factory floor where systems have been upgraded from slower serial communications to Ethernet networking. Installation is easy with a single switch setting, one end is set for local and the other remote. The ED3141 is used in pairs to extend Ethernet connectivity over existing voice grade copper wire.

KEY FEATURES

> Complies with NEMA TS1 & TS2 Environmental requirements for Traffic control equipment
> Complies with IEC61000-6-2 EMC Generic standard immunity for Industrial environment
> Operates transparent to higher layer protocols such as TCP/IP
> Ethernet Port: 10/100Mbps-Full/Half-duplex, Auto-Negotiation, Auto-MDI/MDIX
> Ethernet Extender(RJ-11 and Terminal Block) Port: Symmetrical on the VDSL, High-speed Full-duplex 50Mbps communications link over existing copper Telephone line
> Support DIP switch to select Local or Remote side
> Ten speeds with speed indicator LEDs on front panel of unit, Up to 50Mbps @ about 300meters (984ft.), Down to 1Mbps @ about 1,900meters (6,232ft.)
> Redundant power inputs with Terminal Block and DC Jack
> -40C to 75C (-40F to 167F) operating temperature range
> Sardened aluminum case
> Supports DIN-Rail or Panel Mounting installation