The ED3101 is a point-to-point Ethernet Extender that efficiently extends 10/100Ethernet circuits to over 300meters (984feet) at 50Mbits using existing straight pair copper wire. The ED3101 will allow Ethernet connectivity in existing facilities without pulling extra cable. This is the perfect solution to Ethernet on the factory floor where systems have been upgraded from slower serial communications to Ethernet networking. Installation is easy with a single switch setting, one end is set for local and the other remote. The ED3101 is used in pairs to extend Ethernet connectivity over existing voice grade copper wire.

KEY FEATURES

> Operates transparent to higher layer protocols such as TCP/IP
> Ethernet Port: 10/100Mbps-Full/Half-duplex, Auto-Negotiation, Auto-MDI/MDIX
> Ethernet Extender(RJ-11) Port: Symmetrical on the VDSL, High-speed Full-duplex 50Mbps communications link over existing copper Telephone line
> Support DIP switch to select Local or Remote side
> Ten speeds with speed indicator LEDs on top of unit, Up to 50Mbps @ about 300meters (984ft.), Down to 1Mbps @ about 1,900meters (6,232ft.)
> -20C to 60C (-4F to 140F) operating temperature range
> Hardened aluminum case
> Supports DIN-Rail, Wall Mounting installation or expansion use with EMC1600 media converter chassis system